Recent content by deuginthesky
-
zhaolu z3 dac
TG-Link is ways better than USB. Use a D3 with the sndscape sound card via TG-Link and you'll change your mind.- deuginthesky
- Post #3
- Forum: Computer Audio
-
Audiophile Sound Card.
Look more at sound card with a good digital output, some have no analog output.- deuginthesky
- Post #4
- Forum: Computer Audio
-
Silmic II or Nichicon Muse KZ?
Quote: Originally Posted by wnmnkh I had been too busy to get in here.... I will use Muse KG for main caps for sigma22, and will use Silmic II on rest. Don't forget the Rubycon ZLH for PSU, very low ESR.- deuginthesky
- Post #19
- Forum: DIY (Do-It-Yourself) Discussions
-
Review: ZERO 24 BIT/192KHz DAC/Headphone Amp/Pre-Amp
Quote: Originally Posted by Penchum It is just ANDREA again. Please ignore him. There were a few comparisons earlier on, but I don't remember the model numbers. Anyway, the Zero did pretty well, considering it cost less and had a better headphone amp by default, so no one thought too...- deuginthesky
- Post #3,597
- Forum: Headphone Amps (full-size)
-
removing SAA7345 on Philips CD721 player
How to replace the laser pick-up assembly of your CD player Would cut the connexions as on the picture make the job to get a NOS TDA1545A player ?- deuginthesky
- Post #7
- Forum: DIY (Do-It-Yourself) Discussions
-
LME49710 vs OPA627s ?
Quote: Originally Posted by Henmyr Is there a reason to use single op-amps instead of duals? For exemple 2x LME49710 on brown dog adapter instead of LME49720. Less offset, less noise and less bias.- deuginthesky
- Post #25
- Forum: DIY (Do-It-Yourself) Discussions
-
LME49710 vs OPA627s ?
Quote: Originally Posted by RFL Perhaps you haven't used it correctly. The LT1028 has such a low (lower than that of the LME49720) specified noise voltage that you would have bionic hearing Regarding tonality, the LME49720 is cold-blue whereas the LT1364 is warm-yellow. I like...- deuginthesky
- Post #21
- Forum: DIY (Do-It-Yourself) Discussions
-
LME49710 vs OPA627s ?
Not precise enough, noisier, less realistic to me. Colors and tastes...- deuginthesky
- Post #19
- Forum: DIY (Do-It-Yourself) Discussions
-
Not Impressed By The Zhaolu; Thinking Of Selling It
Even 100% stock, the zhaolus are good sounding DACs. I got a 2.5 and a 3, both are great.- deuginthesky
- Post #41
- Forum: Dedicated Source Components
-
LME49710 vs OPA627s ?
Quote: Originally Posted by majkel LT1028 is more transparent than the LT1363, and I've learnt how to make it stable at gain of 1, even without additional capacitors. it's described in the datasheet. Heard LT1028 and LME49710 on same CDP (tweaked philips) , I prefer the LME.- deuginthesky
- Post #18
- Forum: DIY (Do-It-Yourself) Discussions
-
LME49710 vs OPA627s ?
LME49710 is the single version of the LME49720 which is to me the same as the LM4562.- deuginthesky
- Post #16
- Forum: DIY (Do-It-Yourself) Discussions
-
The "mod your Zhalou" Thread
Quote: Originally Posted by minivan does any1 know where to get replacement for the 2 regulators on the top left of this picture? they are c5171 and a1930. what brand are they? what are the spec for their output? any other regulators i can used to substitute them? thanks Only...- deuginthesky
- Post #1,983
- Forum: Dedicated Source Components
-
The "mod your Zhalou" Thread
Quote: Originally Posted by minivan does any1 know where to get replacement for the 2 regulators on the top left of this picture? they are c5171 and a1930. what brand are they? what are the spec for their output? any other regulators i can used to substitute them? thanks Only...- deuginthesky
- Post #1,982
- Forum: Dedicated Source Components
-
The "mod your Zhalou" Thread
Quote: Originally Posted by minivan does any1 know where to get replacement for the 2 regulators on the top left of this picture? they are c5171 and a1930. what brand are they? what are the spec for their output? any other regulators i can used to substitute them? thanks Only...- deuginthesky
- Post #1,981
- Forum: Dedicated Source Components