Jethrosang
100+ Head-Fier
- Joined
- Jun 16, 2012
- Posts
- 163
- Likes
- 17
I tried to check out the detail of this IEM, ... ...I tried my best but I am not 100% sure, I can't be to be honest.
Thanks a lot for those digging. I think it may hiss, because it is quite sensitive, but I will bit the bullet and hope for the best. Here's fingers crossing for Cayin to release a firmware that could solve this problem.
Thanks once again for the help.
My Noble K10 are more sensitive than my JH Angie, even with the higher impedance, so unfortunately they will hiss with the balanced output on the N5. I can't speak for the other Noble offerings though. That said, the single ended output is very good so I wouldn't stress too much if your sensitive IEMs hiss with balanced out. Just use the single ended connection and enjoy!
Well, the P configuration is tricky to drive because of its high impedance, single-ended is quite under-powered, and once properly powered, its experience is rewarding. So, here's hoping it won't disappoint.