Feb 12, 2009 at 11:16 AM Thread Starter Post #1 of 2 MR.HIFI New Head-Fier Joined Feb 11, 2009 Posts 7 Likes 0 Who can tell me how to make the lines like this in myself?Ilove diy!please!
Feb 13, 2009 at 5:05 AM Post #2 of 2 Phil Ramsay 100+ Head-Fier Joined Dec 11, 2003 Posts 292 Likes 11 That does look nice... but probably not that hard to do yourself, if you like handwork. Neutrik 3.5 MM Right Angle 3 pole plug (NTP3RC-B) Looks like a 4 wire Litz braid for the main section (thicker) cable section). Chimera Labs Do it yourself - braiding Audio Cable and then transitions to twisted pair where it presumably would go to each headphone cup. The Litz braid, and the twisted pair appears to be custom sheathed in shrink tube. If you can get the right size shrink tubing by the foot, it shouldn't be too tough to braid the wires and shrink the tubing on. That's what it looks like to me... I did some very similar cables for my HD25-1's, although I used Techflex instead of shrink. Kinda want to try the shrink now...
That does look nice... but probably not that hard to do yourself, if you like handwork. Neutrik 3.5 MM Right Angle 3 pole plug (NTP3RC-B) Looks like a 4 wire Litz braid for the main section (thicker) cable section). Chimera Labs Do it yourself - braiding Audio Cable and then transitions to twisted pair where it presumably would go to each headphone cup. The Litz braid, and the twisted pair appears to be custom sheathed in shrink tube. If you can get the right size shrink tubing by the foot, it shouldn't be too tough to braid the wires and shrink the tubing on. That's what it looks like to me... I did some very similar cables for my HD25-1's, although I used Techflex instead of shrink. Kinda want to try the shrink now...