so it's got both DAC and ADC
I can't seem to get the sampling rate for the DAC, but I see that it is 200kHz for the ADC (not sure if that means its the same for DAC). These are the specs specifically for the DAC:
Analog Output:
Number of channels 4, pseudo-differential
optically isolated
Type of DAC double buffered, multiplying
Output connector BNC
Resolution 18-bit converter
16-bit data (1 in 65536)
Output range -10.24 to +10.239 Volts
Conversion speed software selectable, 5µs max
Gain error 0.2% of FSR
Gain linearity <2 dB
Gain drift ±25 ppm of FSR/ °C
Signal-to-noise ratio 116 dB
InstruTECH ITC-18
16-bit Data Acquisition Interface5
Output impedance 200 _ (for output overload pro
tection)
Short circuit to ground indefinite
Output load current 8 mA typical
and then the "main features"
- All synchronous analog and digital channels are optically isolated
- Eight simultaneously sampling differential analog input channels
- Eight 18-bit 200 kHz A/D converters
- 200 kHz to 12 Hz sampling in 1.25 µS steps (200 kHz max aggregate)
- Programmable input gain: 1x, 2x, 5x, 10x
- Analog input range: + 10.24 Volts
- Four pseudo differential analog output channels
- Four 18-bit instrumentation grade D/A converters
- Analog output range: + 10.24 Volts
- Sixteen synchronous digital input channels
- Thirty-two synchronous digital output channels, fourteen with current sink
- Sixteen asynchronous digital output channels
- Large 1024 kilosample FIFO
- PCI, and USB 2.0 host interfaces available
- Easy installation, no IRQ or DMA channel settings
- Compatible with Windows 2000, XP, Vista (32-bit only), MacOS classic, MacOS X (PPC and intel), LabView for Windows, MatLab and Linux
But this is seperate from the actual amplifier, whose specs are here http://www.dagan.com/bvc-700.htm
I would love if this could work