Trying to fix my Breyer Dynamic DT990 Pro
Jul 16, 2019 at 1:31 PM Thread Starter Post #1 of 2

EmerFlame

New Head-Fier
Joined
Jul 16, 2019
Posts
1
Likes
0
Location
Tajikistan
zh1b3Mr

Hey,
I have had these headphones not too long and I found that the cord would sometimes slip out of the ear ear piece. I had been inching it back in until one day I inched it back in and the left ear piece stoped working. I took it apart and looked at it but can’t tell if something is broken. I doubt it is broken in the cord but can someone tell me if Something is broken. I cheacked the right side, it works and looks good but can’t figure out what is wrong with the left side.

https://ibb.co/zh1b3Mr
 
Last edited:
Jul 17, 2019 at 4:27 AM Post #2 of 2
The cable here looks like it's a little bit bent in a strange way that possibly resulted in some cable fatigue... but that could just be the angle of the photo.
Everything else looks visibly OK to me.

upload_2019-7-17_10-22-31.png


Do you have a multimeter to test the left driver for continuity?
That would rule out a driver failure.

This is assuming you don't have a warranty or some customer service that could replace the headphone for free as a 'faulty unit'.
Since you said you didn't have it for long.
 

Users who are viewing this thread

Back
Top