[vrao81]

Whats the consensus on stereo stepped attenuators purchased off ebay? Like http://www.ebay.com/itm/DACT-Type-21-Stepped-Attenuator-Potentiometer-100K-2A3-/190550564515?pt=LH_DefaultDomain_0&hash=item2c5db2dea3 OR http://www.ebay.com/itm/SMT-Resistor-Step-Attenuator-100K-Volume-Control-/270818018575?pt=Vintage_Electronics_R2&hash=item3f0e03050f
I think are fairly well regarded over at diyaudio forums, just wondering what head-fiers thought of them.

 

[buggalugs]

Well my experience is that they are pretty naff. The pads to solder flying leads to are feeble and easily lift; the shaft is a small non standard size and you'll probably need to source a specific knob. The contacts get very noisy after a few weeks. You are always searching for that "in between" point when in use. I actually binned one recently.
 

 

[particleman14]

good cheap pots.  I've used them before and they sound just fine.  I prefer to use them for mockups.  if you put a big knob on them the feel is not too bad.   

 

[Armaegis]

While I've never ordered from them, I've heard some people say that the stuff from lasercollection is good. 

 

[civilmonkey]

I used one for a CTH rev A.  I find it to be pretty good, I just found a knob (also on ebay) with a hole for a 1/4" shaft, it worked no problems.  It sounds great to me, a lot of clarity and was certainly much much better than a generic pot I was using until the ebay one arrived. 
 
Buggalugs is right though they are fragile; the pads do lift easily, and I snapped one pot by over-tightening it to the case.  So, if you only solder once, and take a bit of care using it, it might work fine for your application.