ohn
New Head-Fier
- Joined
- Mar 23, 2006
- Posts
- 17
- Likes
- 10
I just wanted to see if this was typical of other peoples' experiences.
Have a pair of e3's that I've been using for about 2 years now (maybe more? i forget...)
The cables stiffen noticeably when the ambient temperature drops, to the point that i feel like i need to warm them up in my hands before bending them.
When I went snowboarding a few weeks ago, i suppose it was the combination of movement and the cold, but the plastic outer layer cracked, and since then, the copper wire that provides structure directly underneath the plastic has frayed, and just a few days ago, the signal to the right earphone went out. Specifically, there have been cracks about an inch from the actual bud, and right where the cord bends under the rubber sleeve used to adjust the length of free dangling cord.
Now. I know that I shouldn't have been using these while snowboarding (with wind chill, it was probably close to 0 degrees or slightly negative), probably should have used my crappy old earphones, but is the problem inherent in the material that shure uses, since the cord is supposed to stay a certain way while looped over the back of the ear?
Also. Looking for my next purchase. I can't complain about the sound quality of the shures, so was looking at the e4's. Also considering the ety 4's and the super.fi 5's... the last of which i've heard has better bass output. I listen to a broad range of music, from classical to jazz to rock to hiphop to techno, and would appreciate the bump in bass for the jazz and hiphop but don't want to sacrifice too much in the upper end.
any recommendations? i couldn't find any thorough comparisons on the lengthier review page...
budget is about $250, so could even go for a used pair of canal phones that are slightly higher priced...
Have a pair of e3's that I've been using for about 2 years now (maybe more? i forget...)
The cables stiffen noticeably when the ambient temperature drops, to the point that i feel like i need to warm them up in my hands before bending them.
When I went snowboarding a few weeks ago, i suppose it was the combination of movement and the cold, but the plastic outer layer cracked, and since then, the copper wire that provides structure directly underneath the plastic has frayed, and just a few days ago, the signal to the right earphone went out. Specifically, there have been cracks about an inch from the actual bud, and right where the cord bends under the rubber sleeve used to adjust the length of free dangling cord.
Now. I know that I shouldn't have been using these while snowboarding (with wind chill, it was probably close to 0 degrees or slightly negative), probably should have used my crappy old earphones, but is the problem inherent in the material that shure uses, since the cord is supposed to stay a certain way while looped over the back of the ear?
Also. Looking for my next purchase. I can't complain about the sound quality of the shures, so was looking at the e4's. Also considering the ety 4's and the super.fi 5's... the last of which i've heard has better bass output. I listen to a broad range of music, from classical to jazz to rock to hiphop to techno, and would appreciate the bump in bass for the jazz and hiphop but don't want to sacrifice too much in the upper end.
any recommendations? i couldn't find any thorough comparisons on the lengthier review page...
budget is about $250, so could even go for a used pair of canal phones that are slightly higher priced...