[BabylonDown]

Hey guys. I'm just wondering how, if possible to connect my Scarlett 2i2 and LSR305 monitors to my PSW10 subwoofer?

I imagine it would start as

2i2 TRS L&R Line Output > PSW10 RCA L&R Line In

How do I connect the monitors to the sub if it only has wire bindings?

 

[BabylonDown]

Nooobody?

 

[PurpleAngel]

The Polk Audio PSW10 sub-woofer was not designed to work with studio monitors (LSR-305)
Sell off the Polk Audio and buy the Monoprice 10" sub-woofer.
https://www.monoprice.com/product?p_id=605999

 

[CrumptyDumpty]

Nooobody?

This is a bit of an odd subwoofer, and I was almost distraught trying to work it into my setup using the Focusrite as well as my Eris Presonus 4.5 monitors. The typical route you would expect, using TRS or RCA from audio interface to subwoofer, and then to studio monitors, will not work.

You must piggyback the powered signal from the speaker wires that connect the reference monitors, into the Polk speaker inputs, at the bottom, on the back. I’ve tried a few convoluted pathways, but this is the only one that works.