Sayajin
100+ Head-Fier
- Joined
- Aug 2, 2008
- Posts
- 404
- Likes
- 12
Hi guys at DIY.
I'm working on a touchpad on one of my pmp's (Meizu M6) that some part of it don't really like to react very good any longer the way it supposed to do.
The main problem, it's attached to the front cover with these very small pins of plastic. You can see some of those bellow on the picture I made and so also a little bit of my project.
No trouble what I see break them up and removing the pad, easy job.. but what I gonna do when I need to assemble it and keep the pad solid into place again?
I could use super glue to keep it into place, that's one way I see. It just that I don't beleive it would hold, at least not as it would be before.
Guys do you maybe know a better solution here what I could do? anyone?
I'm working on a touchpad on one of my pmp's (Meizu M6) that some part of it don't really like to react very good any longer the way it supposed to do.
The main problem, it's attached to the front cover with these very small pins of plastic. You can see some of those bellow on the picture I made and so also a little bit of my project.
No trouble what I see break them up and removing the pad, easy job.. but what I gonna do when I need to assemble it and keep the pad solid into place again?
I could use super glue to keep it into place, that's one way I see. It just that I don't beleive it would hold, at least not as it would be before.
Guys do you maybe know a better solution here what I could do? anyone?