THA CAZ
New Head-Fier
- Joined
- Feb 11, 2010
- Posts
- 22
- Likes
- 10
Hey all,
After doing some leg work, and some good old trail and error, and some soldering iron burns.
I have come to the conclusion it is MUCH easier to re-cable/wire something from the headphone driver itself rather than mid cable.
My question is where do I start. I have looked through the DIYLR a bit, and came up with nothing that fits my needs.
I am looking for a 12"-18" wire (I realize I may have to buy in bulk, then cut it down, but I would rather buy it clean so I don't have to do any work besides solder the out's to the drivers). 3.5mm in jack (for a Sansa Clip Zip. I was thinking of doing a headband mod so I could just clip it there forever, but collar is fine for now.
Any help? Much appreciated.
On
After doing some leg work, and some good old trail and error, and some soldering iron burns.
I have come to the conclusion it is MUCH easier to re-cable/wire something from the headphone driver itself rather than mid cable.My question is where do I start. I have looked through the DIYLR a bit, and came up with nothing that fits my needs.
I am looking for a 12"-18" wire (I realize I may have to buy in bulk, then cut it down, but I would rather buy it clean so I don't have to do any work besides solder the out's to the drivers). 3.5mm in jack (for a Sansa Clip Zip. I was thinking of doing a headband mod so I could just clip it there forever, but collar is fine for now.
Any help? Much appreciated.
On
