devin_mm
1000+ Head-Fier
- Joined
- Aug 25, 2006
- Posts
- 1,174
- Likes
- 12
I'm trying to balance my W5000s but I'm getting an interesting issue.
I cut off the 1/4" end, stripped the wires, tinned the ends but now I'm trying to measure the resistance across the drivers to see which ground goes with each channel. The issue is when I measure from using a ground and either channel I get 37.2 ohms which I don't think is right. Does anyone have any ideas/suggestions?
Thanks,
I cut off the 1/4" end, stripped the wires, tinned the ends but now I'm trying to measure the resistance across the drivers to see which ground goes with each channel. The issue is when I measure from using a ground and either channel I get 37.2 ohms which I don't think is right. Does anyone have any ideas/suggestions?
Thanks,
