[tilt]

What watt ratting is suggested for this application?

Mouse is hovering over the order button at PC

Also, those are 100k ohms each right?
http://www6.head-fi.org/forums/showp...6&postcount=17
He mentioned he rasied the output resistance to 200k, so 100k for each film cap?

 

[dhp]

the resistors to the left of the RCAs look like 1/8W vishay/dales and the 2 resistors on the right connecting the white caps look like 1/4W vishay/dales. KEep in mind that for all intents and purposes, 1/8W vds are 1/4W and 1/4W are 1/2W

 

[tilt]

i don't think www.partsconnexsion.com has vishay/dales. They have an area called vishay, but they're black. http://www.partsconnexion.com/catalo.../sheet012.html

I'd want to use VTA 55 - 0.3 watt's?

 

[tilt]

also, would to be so bad to play it safe and just get 1/2 watt's? or is that detremental to the sound?

 

[dhp]

i do not believe there is any discernable difference in sound

 

[tilt]

cool, thanx!

 

[JahJahBinks]

I ordered vishay before from Mouser.

 

[Daroid]

I suppose that the input signal after the coupling capacitors is connected to the op-amp inputs, right ?

Then about zero current will be drawn from the inputs, so the calculations would be simple.

P=U^2/R

For input signal level it could be anything, since manufacturers use different outputs, and if the output is amplified.... But 2.5V is a good measure.

The P=2.5^2/100 = 0,0625 mW

1/8W is 125mW

So it would work well enough.
If the don't go to the op-amps, do a KCL for the circuit until you find the current that pass through the input section....