Pimeta case recommendation
Mar 22, 2004 at 4:16 AM Post #16 of 20
Nope.... need to use the H67 series case to fit two batteries.
Then you need to bust out the dremel to get them to fit.
evil_smiley.gif
 
Apr 5, 2004 at 12:04 PM Post #18 of 20
Hahaha... good job MisterX.
biggrin.gif


I was wondering how easy the Bulgin battery holders were to operate? I want to put them into a 3" wide hammond case, but the screw mounting flaps on the battery holders extend out over the edge of the case. I was wondering if you think these battery holders would hold up if they were superglued onto the back panel? Or is this as bad of an idea as mounting the battery holders into the side of the case?
wink.gif


The rocker battery holders are tempting, but there's not enough panel real estate =P.

file.ashx
 
You must log in or register to reply here.

Users who are viewing this thread

Total: 2 (members: 0, guests: 2)
Back
Top