[alibb]

I’m new to this. I initially wanted to solder my cable to 2 pins connector but my 2 pin IEM driver broke.

MMCX have 3 “pins” which is to “+” and which is to “-“? Or it doesn’t matter? Will a cable with mic affect the soldering?

Sorry really noobie question here. I tried searching online for wiring instructions but found none. (Except for the female one) I want to solder to the make. Maybe I didn’t look hard enough, would appreciate your help.

Thanks.

 

[NA Blur]

https://www.head-fi.org/articles/diy-cable-info-and-resources.14308/

Shell is ground hence there are 2 terminals for that labeled 1 and 3 on your pic. The center pin is the signal. The cable with the color is usually the signal while the bare cable is typically ground.

 

[Voxata]

I always use a tone tester to map an existing cable as I build a new one. Mark down your notes and also test the connectors to see how they are rigged up. Makes life easy.

 

[NA Blur]

Did you get your cable wired up?

 

[alibb]

Did you get your cable wired up?

Oh, yes, thanks a lot for the information!
It was a painful and frustrating process ... even with flux ...

In the end, dad has to help me as I just keep screwing up... LOL!
Very satisfying though at the end of it!

I'm glad I "saved" the earpiece which driver kapuut due to water damage ...
Thanks to you and @Voxata!!!

 

[alibb]

I always use a tone tester to map an existing cable as I build a new one. Mark down your notes and also test the connectors to see how they are rigged up. Makes life easy.

Thanks for your advise!!
I haven't had the need to use those tools.
I was lucky in many ways and got the job done ...
after struggling with the sodlering though LOL