rickcr42
Are YOU talkin' to me?
- Joined
- Jun 21, 2001
- Posts
- 13,874
- Likes
- 15
are you still getting the oscillation ? Looking at your website I noticed the board out of the case had some longish wires to the mosfets.That could be the problem right there.
If you break the wire close to the gate of the mosfet you could insert a resistor of from 100 to 220 ohms.A gate resistor on the board is too far away to do much good
If you break the wire close to the gate of the mosfet you could insert a resistor of from 100 to 220 ohms.A gate resistor on the board is too far away to do much good