[Noelstan]

Small resistor to the right of the corner 330 cap! It burned on me. (on my board) Is it a 50 ohm perhaps? It would be nice to know for sure! Thanks a lot in advance!

 

[NA Blur]

It's hard for me to tell due to the color beings out of focus. Snap another pic for us in better focus on that resister and we can help. Also, if you have to replace it anyway you can remove it and measure it with a DMM yeah?

How do you know it has burned out? It looks fine to me.

 

[Noelstan]

That is not my board! The one on my board is totally fried! Black/burnt! I was hoping some one could provide a schematic. I tried but could only fine the LD 2. Thanks!

 

[Noelstan]

It's hard for me to tell due to the color beings out of focus. Snap another pic for us in better focus on that resister and we can help. Also, if you have to replace it anyway you can remove it and measure it with a DMM yeah?

How do you know it has burned out? It looks fine to me.

That pic is a pic from the internet. My board burned up that resistor! It is untestable. Do you have a LD Mk3 schematic? Thanks

 

[NA Blur]

If that resistor then goes to the black wire and then the transformer it's the 5kOhm resistor. The small one next to it is the 150kOhm 1w resistor and the large ones are the 180 Ohm 5W resistors.

 

[Noelstan]

Thanks it was a “draining” safety resistor. 5.7K Thanks to all who applied