[Joshatdot]

I been looking thru the Builds posts, and I really like this knob on these CMoy's, what is it?

I can find something similar on Digi-Key's: (it's supposed to be clear gloss, not matte)

226-2008-ND

 

[Fangmasterflex]

I think its on this page at mouser under aluminum control knobs:
http://www.mouser.com/catalog/630/1517.pdf

 

[Joshatdot]

Thanks Fangmasterflex. From the Mouser Catalog PDF, it looks to be the 45KN031. 0.25" knob shaft, mirror finish, 0.61 od, 0.65 h.

 

[Joshatdot]

Anyone know where I can find smaller than .5" diameter knobs? w/6mm or .25" shaft size.

 

[amb]

Quote:

Originally Posted by Joshatdot /img/forum/go_quote.gif Anyone know where I can find smaller than .5" diameter knobs? w/6mm or .25" shaft size.

How about these Keystone knobs from Digikey:
http://dkc3.digikey.com/PDF/T072/P1660.pdf (figure 1)

Or some of the Eagle Plastic Devices knobs from Mouser:
http://www.mouser.com/catalog/630/1516.pdf (aluminum knobs figure B or E, and combination aluminum/plastic figure A) or
http://www.mouser.com/catalog/630/1517.pdf (aluminum control knobs figure D).
There are a few others which are just a hair over 0.5" too.

 

[amb]

.

 

[Joshatdot]

Thanks amb! what do you think of this one? (it's supposed to be clear gloss, not clear matte).

 

[amb]

Quote:

Originally Posted by Joshatdot /img/forum/go_quote.gif Thanks amb! what do you think of this one? (it's supposed to be clear gloss, not clear matte).

Nice lookin'.

 

[Joshatdot]

I wish I had my own metal lathe and stuffs, I would like to make my own

 

[colonelkernel8]

Quote:

Originally Posted by Joshatdot /img/forum/go_quote.gif I wish I had my own metal lathe and stuffs, I would like to make my own

Josh, I have access to a lathe and I have some left over aluminum, would you like me to make you one?

 

[Joshatdot]

Quote:

Originally Posted by colonelkernel8 /img/forum/go_quote.gif Josh, I have access to a lathe and I have some left over aluminum, would you like me to make you one?

Sure that would be cool! 6mm Shaft, and mebby .4" OD? x .5" length

 

[threEchelon]

Quote:

Originally Posted by colonelkernel8 /img/forum/go_quote.gif Josh, I have access to a lathe and I have some left over aluminum, would you like me to make you one?

Hmm. Left over aluminum, eh? Do you have any of those feet for sale?

 

[Joshatdot]

colonelkernel8, oh yeah forgot to say it would be for a Alps RK097.