suba3333
100+ Head-Fier
- Joined
- Dec 22, 2006
- Posts
- 178
- Likes
- 11
So I dropped my nano. The top side/panel, where to on/off slider sits, is still in place at both ends but in the middle it is now bending upwards and sticking out of the main body. I tried to push it back in but it always pops up again. I thought about glueing it but the gap is too small to get any glue in there so I would need first to remove the whole panel. How to remove the panel w/out damaging other bits? or is it better to leave as is? Thanks.
