powerhouse
New Head-Fier
- Joined
- Jul 28, 2009
- Posts
- 13
- Likes
- 0
My frankenstein Grado sr60's stitched together with solder, shrink tube, and tape finally bit the dust, so I've ordered a pair of Beyer DT880/600's and a Fiio E9 amp. I have a couple questions about this setup.
1.) My Sound card is an auzentech forte with a built-in headphone amp. I don't see any other line out, do I just use the headphone out to connect to my E9 amp?
2.) I assume my headphone detection will not work through the amp, right? Does that mean I have to switch the driver from 2.1 to headphones every time I switch?
3.) Is it best to keep the computer volume at 100% or less?
Thanks,
1.) My Sound card is an auzentech forte with a built-in headphone amp. I don't see any other line out, do I just use the headphone out to connect to my E9 amp?
2.) I assume my headphone detection will not work through the amp, right? Does that mean I have to switch the driver from 2.1 to headphones every time I switch?
3.) Is it best to keep the computer volume at 100% or less?
Thanks,