Hey..
So I'm going to finish assembling my end to end balanced stack, and most of my full sized cans are already balanced, except my dt990...
I found a guy on Reddit that does it for a commission but the shipping is more expensive than the mod..
Now my question is, I can solder pretty good and my Dremel skills are adequate, but I've no clue about electronics... if I could get a clear idea what needs to be soldered where I feel like I can do it myself but my confidence isn't too high...
Do you think a beginner like me is up to the task? Can someone give me exact explanation how do I solder everything correctly?
Thanks
So I'm going to finish assembling my end to end balanced stack, and most of my full sized cans are already balanced, except my dt990...
I found a guy on Reddit that does it for a commission but the shipping is more expensive than the mod..
Now my question is, I can solder pretty good and my Dremel skills are adequate, but I've no clue about electronics... if I could get a clear idea what needs to be soldered where I feel like I can do it myself but my confidence isn't too high...
Do you think a beginner like me is up to the task? Can someone give me exact explanation how do I solder everything correctly?
Thanks