kevin645
Head-Fier
- Joined
- Dec 16, 2011
- Posts
- 51
- Likes
- 10
Hey Guys!
So far, I have completed sodering the entire board. Now I am at the testing phase and today in my robotic's class it did not work very well. But I found out after robotic's that i had switched the input and out of the right channel. It did work for a fraction of time and also I had found small short and that I didn't seat the amp into the socket completely. Tomorrow I should have the amp running with alligator clips.
Now I tried to see how I am going to seat the entire circuit board and 2 batteries leaving room for the Panel components. I used some foam as a mockup and it seems that my audio jack would be sitting on my chip and the top of the altoids can make not close completely.
Any suggestions? Any pictures or previous builds that may help me out?
So far, I have completed sodering the entire board. Now I am at the testing phase and today in my robotic's class it did not work very well. But I found out after robotic's that i had switched the input and out of the right channel. It did work for a fraction of time and also I had found small short and that I didn't seat the amp into the socket completely. Tomorrow I should have the amp running with alligator clips.
Now I tried to see how I am going to seat the entire circuit board and 2 batteries leaving room for the Panel components. I used some foam as a mockup and it seems that my audio jack would be sitting on my chip and the top of the altoids can make not close completely.
Any suggestions? Any pictures or previous builds that may help me out?
