-
-
You guys are clueless. But it's a fun read. -
Pars posted a comment on classifieds listing DCA / Drop Ether CX + Dekoni pads.Interested. Would you consider shipping to the US (Chicago area)? Thanks, Chris
-
Pars replied to the thread In need of some DIY wire advise.Yep. Found this, which matches their port descriptions for the headphone jacks: You would not connect the sleeves of either 1/4" to...
-
-
Pars replied to the thread KG CFA3 headphone amp.A little late on this, but one reason why I modified a version of Kevin's protect board to incorporate a mute switch which completely...
-
Pars posted a comment on classifieds listing Audeze LCD2 Classic.n/m
-
Pars reacted to JaquesGelee's post in the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers with
Like.
Hey sweeties, I was finally able to finish my first Open Alpha build. It was much harder than i thought to realize my preferences. I... -
Pars replied to the thread KG CFA3 headphone amp.The output stage of the CFA3 doesn't really look stripped down from the CFA2 to me, but I haven't compared them closely. On the CFA3...
-
Pars replied to the thread Nakamichi TA-2A speaker amp common ground??? Please help with wiring..Do you have a multimeter with ohms functionality? If so, check continuity between the - speaker terminals. If 0 ohms (or <1 ohm), you...
-
Pars replied to the thread KG CFA3 headphone amp.Not necessarily afraid of them. I've built around 5 of the SS Mini Dynalos, which are pretty much all SMD. The problems with SMD include...
-
Pars replied to the thread kgsshv carbon.You could also check with Spritzer on his site: https://mjolnir-audio.com/products/
-
Pars replied to the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers.After getting the baffles and pad rings cleaned up, and figuring out how much force, best tools, etc., I got em. I used a small chisel...
-
Pars replied to the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers.Got a set of the baffles and pad rings cleaned up. It looks like the support settings used were a bit aggressive, as there was a solid...
-
-
Pars replied to the thread "Open Alpha" T50 3D printed headphone project from MrSpeakers.A friend of mine printed these for me using PLA (and the original files). They look a bit rough on the inside, and considerable clean-up...
-
-
Pars replied to the thread Repairing a Go-Vibe V4 headphone amp (DC jack replacement).I'd probably use the 3rd jack you list. The higher current spec just means the jack can handle more current than the other 2 will...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
