[Angaria]

I'm wondering if it's possible to use the rca and balanced outputs from a citypulse to simultaneously feed into 2 amps. I've only got one amp @ the moment, so I wondered if anyone had experience with this.

 

[Bones13]

Not sure if the timing works with that scheme. Considered a "Y" connector from either of the 2 outputs on your DAC?

 

[krmathis]

That might work.
But beware that the balanced line output a higher signal voltage (line level) than single ended. So you will most probably need two volume controls to make them even.

 

[sejarzo]

On some units with balanced and unbalanced outputs, the signal level between pin 2 ("hot") and pin 1 (signal ground) is exactly the same as it is on the RCA outputs--that's the situation with the 0404 USB.

However, from the pictures of the rear panel of the Citypulse and the description, I think there is a problem--are the XLR outputs connected to the variable output stage via the volume control, or are they at a fixed output level?

 

[infinitesymphony]

Four RCA-RCA cables and two of these:



Or two single RCA to double RCA Y-cables, preferably made by BJC or a Head-Fier.