[afg34]

So today I decided to follow this guide and do the removable cable mod which i really want as I dislike the original cable.
 
So I followed through and I ended up snapping the three little wires from the driver pcb and now I don't know how they connect back.
 
here is a picture: http://imgur.com/a/UaGEO
 
I'm pretty sure the green L+ wire goes to the far right but there are two possible places it can be soldered to on the right. so im confused about that.
 
Then I am not sure about the other two wires because it is not clear from the picutres in the guide. I should have taken a picture of the setup before i did anything but i guess that was my mistake.
 
 
Any insight on how to do this?

 

[afg34]

So i messaged the creator of the mod and he let me know where to solder however I am terrible at soldering and it didn't end up working.
 
 
If anyone in OTTAWA, CANADA is reading this and is good at this stuff I will pay you to help me with this small project