Joe Garfield
100+ Head-Fier
I received a power transformer that has the bottom few E-I laminations hanging down. The corners will get clamped when installed, but the legs of the 'E' will still hang down. Can anyone suggest an appropriate adhesive?
The laminations/transformer have been dipped in varnish. One thought was to use Red Insulating Varnish, but then I realized it's meant more for coatings where a thin layer can evaporate and cure. I don't know how well it will cure when clamped between laminations. So second thought was a high temp epoxy.
I can't post a pic, but if you look at the one below you can imagine the bottom lamination separating and hanging down a little.
Any thoughts?
Thank you
The laminations/transformer have been dipped in varnish. One thought was to use Red Insulating Varnish, but then I realized it's meant more for coatings where a thin layer can evaporate and cure. I don't know how well it will cure when clamped between laminations. So second thought was a high temp epoxy.
I can't post a pic, but if you look at the one below you can imagine the bottom lamination separating and hanging down a little.
Any thoughts?
Thank you