Xymordos's latest activity
-
Xymordos replied to the thread Home-Made IEMs.Ooh that is very interesting. Where did you buy the round ones? -
The rectangular usound MEMS absolutely need the special amplifier. The round Conamara UA-C0601-2T looks good on the graph above 10K with...
-
最近给朋友做了一些耳机。模仿QDC V3和VX。 '] [/url ] :gs1000微笑::gs1000微笑::gs1000微笑::gs1000微笑::gs1000微笑::gs1000微笑::gs1000微笑::gs1000微笑::gs1000微笑...
-
Xymordos replied to the thread Home-Made IEMs.Can you test a random IEM? Any one will do just to see if it is leaking. If you're using the original soundcard that came with the...
-
Xymordos replied to the thread Home-Made IEMs.What's your measurement setup? I'm pretty sure the 2ohm parallel resistor is ruining the measurements.
-
Xymordos replied to the thread Home-Made IEMs.Ah sorry you need to low pass the 31618, I'm not sure of your tube lengths, but purely guessing, you can try using something like 20ohms...
-
Xymordos replied to the thread Home-Made IEMs.Perhaps try flipping the polarity of the HODVTEC, though I would still prefer to use a series resistor here instead of a parallel one.
-
Xymordos replied to the thread Home-Made IEMs.2 ohm parallel? That's like shorting the driver isn't it?
-
Xymordos replied to the thread Home-Made IEMs.What's the config of your iem?
-
Got my IEC-711 clone calibrated, IEC60318-4. Measurements of KZ ZSX and my DIY 10mm planars, with physical tuning only. The highs are a...
-
I was thinking Vision Ears VE8, but after trying to find the graph i had in mind I noticed that, no it's not that IEM. Instead I think...
-
This is tweeter so you need something in between like ED/2300. While E50DT can produce 2-3kHz its not a good range to use it due to very...
-
Figure I should post what I've done so far here too. End goal is a 1BA mids with 2DD for subbass and treble, but so far I've invested a...
-
So I have all the parts and pieces to build the piotrus-g scary crossover build. I'm going to use size 1206 SMDs. I found some thin pcb...
-
Xymordos replied to the thread Home-Made IEMs.Hmm, it seems that the two drivers' resonance peaks are very different right?
