-
-
ts8051 replied to the thread DIY Planar magnetic heapdhones.Hello, i have experience in design and constuction of electrostatic and ribbon magnetic headphones and i know that the tension of mylar...
-
ts8051 replied to the thread DIY "ribbon driver" headphones.Hello, I designed and built a new Ribbon Headphones. I printed all parts with 3d printer. I used as a membrane aluminum foil 26 X 60mm...
-
ts8051 replied to the thread My DIY electrostatic headphones.Hello, I use 1.6mm single sided pcb as stator material in order to have flat stators. If you use 0.6mm or 0.5mm single or double sided...
-
ts8051 replied to the thread DIY Planar magnetic heapdhones.Hello, where can I find the required magnets
-
ts8051 replied to the thread DiY Planar Magnetic Headphones (On A Budget).Hello, please let me know where can I find the required magnets.
-
ts8051 replied to the thread My DIY Planar Magnetic Headphones and Drivers.Hello, please tell me about the type and thickness of the membrane you chose.
-
ts8051 replied to the thread My DIY electrostatic headphones.I found this diagram: What can you say about the above diagram? I supose that the stator has the bias voltage and the membranes are...
-
ts8051 replied to the thread My DIY electrostatic headphones.Hello, first what better in frequency responce can we have with aluminum foil instead of membrane? The membrane can be tensioned but...
-
ts8051 replied to the thread My DIY electrostatic headphones.As i understood the membranes are oscilating with180 degrees different in face. I think that it the same can be done if you use a stax...
-
ts8051 replied to the thread My DIY electrostatic headphones.Hello, as i understood you apply signal to the stator from a single ended amplifier and apply high bias voltage on the two membranes. Is...
-
ts8051 replied to the thread My DIY electrostatic headphones.Hello, It is very interesting concept. Where can i find more details about this concept? What amplifier is needed for this construction?
-
ts8051 replied to the thread My DIY electrostatic headphones.Hello, if you have resonance frequensy more than 100Hz did you tested what is the lowest frequency which can produce the headphones? In...
-
ts8051 replied to the thread My DIY electrostatic headphones.Please do you know a simple but effective amplifier for these headphones?
-
ts8051 replied to the thread My DIY electrostatic headphones.Hello, If before hanging the weights apply some presure on the membrane over glass in order to avoid bubbles then we can achive a...
-
ts8051 replied to the thread My DIY electrostatic headphones.In stax headphones the gap is 0.5mm and the membrane stays safe when it plays loud or with mechanical vibrations. There is a secret...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…