-
-
MMythicalEon replied to the thread Home-Made IEMs.If you’re talking about the internal wires, those are litz wires, where you could buy in aliexpress, Taobao, etc. If you’re talking...
-
MA friend told me that SureHold doesn't cure without removing oxygen. It cures with an inhibition layer.
-
MMythicalEon replied to the thread Home-Made IEMs.Oof. Thanks for informing, am editing my post.
-
MMythicalEon replied to the thread Home-Made IEMs.As far as audiology specific lacquers go, there is Egger LP/H Lacquer, Pro3dure L-1, Nicefit Lacquer… I only have the Egger LP/H...
-
MMythicalEon replied to the thread Home-Made IEMs.Sure. But a lot of caveats: 1. I now realize you're likely talking about the USB-C dongle which I don't have, while I use a lightning...
-
MMythicalEon replied to the thread Home-Made IEMs.I personally had zero luck with loopback calibration with the Apple Dongle, so what I did instead was to measure the same IEM with a...
-
MMythicalEon replied to the thread Home-Made IEMs.Looking at the graph, I'm guessing you performed the calibration with the IEM plugged into the mic. When the calibration, which is the...
-
M1. Import STL. Mine is direct from the 3d scanning. 2. Use “T” to translate and align the impressions where you want to cut it. It is...
-
M17. Select all the shell again, Edit > Extract > Enter your desired thickness. Extract Direction should be “Normal”. This would make the...
-
MMythicalEon replied to the thread Home-Made IEMs.Instant Meshes is what I use now, works to create quads and is publicly available for download on GitHub. I'm not sure about the rules...
-
MMythicalEon replied to the thread Home-Made IEMs.Oh! That's reassuring to hear. I suppose it's a matter of practice from here on out then. I'll message you if I end up needing more...
-
MMythicalEon replied to the thread Home-Made IEMs.Definitely easier to get the curves and shapes I want with Meshmixer, albeit at the cost of overly smoothed edges and bumpy surfaces. I...
-
MFusion is not good choice for this. You need something for mesh Out of curiosity how did you manage to convert mesh to BRep so well...
-
MIve dabbled. 3shape is amazing for import and impression manipulation. You can create 3D printed molds for silicone OR finish printed...
-
MMythicalEon utilisez meshmixer pour découper, adoucir et finaliser vos STL, vous perdez votre temps en fusion 360
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…