Opc is having talk of a round 2. He also would like some input on a couple of things.   Dang, hopefully I can swindle my way into getting a couple boards just to have.

I blame my ignorance more then the board. I let the problem get to my head and create frustration beyond what I've ever experienced before.   Ironically, using a PSU that has inaudible noise causes you to notice the amount of noise in the recording during quite sections... thankfully It's...

Quote: 90% of the time the offset stays below 1.0mV, occasionally the DC servo overshoots and can get as high as 2.6mV (which is the highest I've seen). Compared to my last Dynalo build with a standard LM3xx supply, It's much more stable. I would only worry about having excessive DC at...

Motivational pictures, Is it bad that I want to sell it for money to build more headamps? If cost was a factor, with mistakes and repurchases, I believe the total is somewhere around $293 canadian, which, for a world class amp is not much to ask for. Although, without the mistakes I made...

My Dynalo works, I'll post a couple of pictures for inspiration tomorrow

There's always waiting for AMB's δ1, or getting involved in someother group buy for a resistor based attenuator.   I'm a tiny bit skeptical about the gain, I'm using a γ1 as my source. I'll give the 11x a go with my RK27 50K pot and see if I can handle it fine. If not I'll switch to ether 8x...

Check out the "Stackofhay edits", It has the information you need, and more!   Could I get away with lowering R16 value to ~5K and still keep the 10pF compensation cap?

That would be the post I was talking about, It doesn't make much sense. I'll find out sometime (tomorrow maybe), my Dynalo amp board is completely stuffed, and all that's left is the PSU to be completed.   What pot are you referring to?

What kind of horrible things will have to be endured with a gain of x11 and Grado's? What happens if said user upgrades to a higher impedance headphone? Why was the Dynalo designed with a 20K pot in mind, and a gain of x11 times? Is 5x ok with music that's brick walled? or rather more...

I highly suggest reading the construction guild, and all the edits along with with the current guide.   Try investing in building a better PSU rather then a simple LM3xx bipolar supply, which allows it to be up and above the commercial counterparts. Or you could build it for the sake of DIY...

It's for dissipating heat i believe  

36VAC for unloaded on secondary's is fine, check your voltages with respect to ground and compare to this: http://www.amb.org/audio/sigma22/s22_30v_voltages.pdf

Now that's the kicker ain't it? Without actually being able to my Dynalo at the moment without risking of over heating it's voice coil, It's difficult to truly know exactly what I want. But from what I can remember... I also can't truly comment of the sound of the head amp, because I had the...

After using my SR-125i's for the past year, I think it's time to upgrade to something a little more different. I've been thinking about possibly going to a SR-325i. But i've been a bit mixed with what exact direction I should go.   My amp is a Gilmore Dynalo (which is being worked on) Dac...

I just need to add the optional OP compensation in case NE5534 is not used. I'd like to generate some interest for a GB, but I don't really know how to go about doing so. You'll be able to find the schematic and improved schematic on Walt Jungs website. There are some other changes to the...