Wow, a cable in the classifieds that might actually be worth what it's listed for, judging by all the other crap on here you could probably double the price GLWS

You can just solder the sleeve bit to the ring or use a small bit of wire to solder between the two

Are you using a 3.5mm trs or trrs if you are using a trrs then tie the ring and sleeve together

Yep, pull them out

Thank you

Does anyone know how to do this braid please, like the cable pictured, it looks to be 8 wire twisted into pairs and then all 4 pairs twisted together but I don't see how the wires stay together so well, thanks in advance for any input

The picture is of a 6.35mm but I assume that the 3.5 is the same, get rid if it and use some epoxy glue and you can also cut a small piece off of the mini xlr strain relief too, I always think that there is more chance that they will dig into the wire and cause a short over time anyway

Cut the two metal strain relief prongs off

+ is to the right of the groove on the right connector and left of the groove on the left connector.

Would like to buy the original Fiio M11 shipped to the UK please, not too fussed about the cosmetic condition but must be fully functional especially all outputs.

Hi, would you send to the UK.

https://www.cosmic-cables.co.uk/diy-wire-accessories-and-sleeving Everything under one virtual roof

It's probably more to do with the wire quality than the solder/ing, nice work though, please tell me where you got the small gold splitter, thanks in advance

Very unlikely