-
-
hrklg01 replied to the thread MYSPHERE 3.1 "FAQ's".Thanks very much for the hint. I will try to check the Onyx hopefully soon.
-
hrklg01 replied to the thread MYSPHERE 3.1 "FAQ's".The "body" plastic part of the cushion is in deed printed. A composite of PA's. But not by simple laser sinter processing. It's made by...
-
hrklg01 replied to the thread MYSPHERE 3.1 "FAQ's".Till now, the headbow cushions wasn't ordered from anybody seperate. However, it's possible to do of course just via the homepage.
-
hrklg01 replied to the thread MYSPHERE 3.1 "FAQ's".Thanks Tom for the fast answer. Yes, The used material for MYSPHERE is really unusual for headphones. It comes from the automotive...
-
hrklg01 replied to the thread k1000 owners club.If you just keep the foam inside, fix it on the outer circle by a white glue (same as used for wood, but a water resistant variant. The...
-
hrklg01 replied to the thread k1000 owners club.@Yggy Both failures are always the main issues which cause the rubb@buzz of the K1K To repair, the membrane has to be glued with a...
-
hrklg01 replied to the thread k1000 owners club.@Yggy Hello, I have to disagree! The gluing from the membrane is defective - just look at the blue marked arrows I did. Also the foam...
-
hrklg01 replied to the thread k1000 owners club.@Yggy According to your very good photos you attached, the two typical failures are still present. 1st membrane gluing + 2nd loose...
-
hrklg01 replied to the thread k1000 owners club.Hello, I'm very sorry that these very old (produced likely in 1991) became rusty mahhet system parts. At that time the surface...
-
hrklg01 replied to the thread k1000 owners club.Those measurments depend very much on the measuring conditions. So if it's measured in a free field and the direction of, or measured in...
-
hrklg01 replied to the thread k1000 owners club.If you are instested in, just drop me a mail to: heinz.renner.hr@gmail.com Best regards, Heinz
-
hrklg01 replied to the thread k1000 owners club.Soweit beide Seiten grundsätzlich funktionieren, könnte ich deine K1000 reparieren. Allerdings hängt es stark von Ihrem Wohnort ab, da...
-
hrklg01 replied to the thread k1000 owners club.The cables are easy to change from the rear to front. Just open the two screws and turn carefully the whole parts.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…