Could the Lundahl transformer be wired to a RCA plug, and so made part of the digital cable? This would enable very easy before after comparisons, and allow it to be used on other dacs as well. John C.

Following the research that some of you have done, I just got in 2 4.7uf Mundorf silver/gold/oil caps for the output. Which way should they be oriented? John C.

Thats what mine did completely stock for the first few hours it was burning in here, but the static was random. It soundid like it wasn't locking on to the digital input. John C.

What is the tube that is used in this? John C.

The phono preamp is used to bring the very low level signal from the cartridge up to where the preamp will be able to use it. Some preamps already have an input for phono(MM) that bypasses the need for a phono pre. If you upgrade to moving coil cartridge you will need a trafo before the...

Samsung has a white sticker that changes color if it gets wet. It also shorts something, and disables the phone. If you peel the sticker off, it will usually restore operation. John C.

For girls, it would have to be the Jeankini. John C.

I bought the G1 on its release. Tmobile has been very slow to release proper accesories for it, luckily online hasn't. I added an adapter to use standard headphones, and a 2300 battery. 16gig card of course. Apps: Pandora Google Sky level barcode scanner weather channel robo...

Welcome to vinyl. If you decide to go to a grado cart, check if youe TT has AC, or DC motor. Grado is an unshielded cart, and very suceptable to picking up hum. John C.

LDR based volume control. Left/Right vol controls on remote. Threat level IIIA metal remote Anti-thump on selector Wired point/point Power supply robust enough that power cords make no difference. John C.

Not waterproof, but its my favorite jacket. http://img10.imageshack.us/img10/7441/jacket1w.jpg http://img15.imageshack.us/img15/5707/jacket2.jpg http://img19.imageshack.us/img19/223/jacket4.jpg When I really want to be warm though, I grab my heavy wool overcoat. John C.

I run a machine shop for a living(no CNC) To do the bigger pieces some of you might want reguires a large miller. You need both travel, and rigidity. Theres very little that can'r be done on a manual mill or lathe, it just takes some thinking and setup time. I farm out any CNC that can't...

I like the Sears Craftman Digitorque. Its easier for a beginner to read than a micrometer type wrench. Also, it goes without saying, NEVER use a torque wrench as a breaker bar. John C.

I buy mostly raw denim, and let it wear in, but I also but a few prewashed jeans. I have quite a few J. Steger jeans, lots of Affliction, a few Robin's, some 501 from before they were junk, and some custom made jeans too. John C.

My everyday watch: Destro Titanium Luminor with stingray band. I'll post some of the rest when I get a chance to shoot them. John C.