earfanatic's latest activity
-
earfanatic replied to the thread DIY Earbuds.I haven't tried it, but You can buy stamps with any logo. They laser etch a rubber sheet for those. Using that rubber sheet and a proper...
-
earfanatic replied to the thread DIY Earbuds.Removing a speaker from the faceplate is always risky. If You do not need the faceplate anymore, then it is better to cut it into...
-
earfanatic replied to the thread DIY Earbuds.Nice illustration. We can also see twisting the tunnel also longer the pipe air passes trough. But does it change the sound? In standard...
-
earfanatic replied to the thread DIY Earbuds.Not yet, but I have saved them if I can make something with them. It is so ridiculously big! :smile:
-
earfanatic replied to the thread DIY Earbuds.If You measure the line resistance with a multimeter, it is 75Ohm, not 150. I believe the left and righ speaker is connected parallel...
-
earfanatic replied to the thread DIY Earbuds.Red is the red, right? I wander on the lower end. The PK shell should be more different than a bell shaped shell, at least I would...
-
earfanatic replied to the thread DIY Earbuds.So, then tell us how you like it when it arrives. :ksc75smile:
-
earfanatic replied to the thread DIY Earbuds.Try heating it, the glue may get more flexible. Then this is my preferred tool. It can be found in kitchen drawers, bars and pubs...
-
earfanatic replied to the thread DIY Earbuds.Why did You choose that if You feel the graph is weird? Titaniums have better treble extension than the fibre/wool variant, but the...
-
earfanatic replied to the thread DIY Earbuds.I had bad luck too with removing covers, so last time when I wanted to remove an original I sacrificed it by cutting up the side to 2mm...
-
earfanatic replied to the thread DIY Earbuds.I will think about it. :hourglass_flowing_sand:
-
earfanatic replied to the thread DIY Earbuds.Yes, it looks good. Did You make them? How hard is it to pull the cable trough? Does it have a special technic?
-
earfanatic replied to the thread DIY Earbuds.I am looking for paracord / fabric / textile cable, that looks like this: I could take apart a cheap earphone but the jack is not even...