-
-
It's a very good shell. I can fit three BAs easily, while two of them are on the bigger side. I do have to arrange everything beforehand... -
I do soldering to the socket, and in between wires then attached to the shell. I stopped soldering them directly to the driver.
-
3.2cm 1mm ID tube, yellow damper @16mm, 100uF + 10 ohm Lpad - looks quite good, maybe a little bit too much sub bass? idk, have to...
-
dnspics replied to the thread Home-Made IEMs.Trank you!
-
Readily ordered lazercut Logo ordered from AliExpress!! Here is the link https://a.aliexpress.com/_mO0RGoT happy building… Greg
-
dnspics replied to the thread Home-Made IEMs.How did you get the logo to look so nice?
-
Hey guys… for Share… Tried an old Design for Guitar friend…changed it a bit… Knowles CI22955 1mmID x20mm 10ohm, orange Knowles ED29689...
-
You could stretch the 2mm tube over the driver to avoid getting glue into the nozzle. That's the safest way I'd say. But I just did what...
-
Sorry, man can't disclose it due to some reasons. I always use different XO. 15-22uf. 10-40R.
-
I would try venting the CI and use something between 0.2 and 0.6mm ID. This sonion 20x53 is big, like a CI but has some internal damper...
-
CI is not a subwoofer I repeat CI is not a subwoofer Its a fullrange driver with wrong pinnae peak If you need sub Go for 38D1XJ Or...
-
Yes! I did a few builds (MASM, MASM Pro) and no matter what, I wasn't feeling the bass. Someone (mattmatt possibly....i'll find and give...
-
17. Select all the shell again, Edit > Extract > Enter your desired thickness. Extract Direction should be “Normal”. This would make the...
-
not to be a wet a blanket, but we're only talking about 1st order BU crossovers AT MOST. And a single series resistor is just lowering...
-
anytime you can accomplish your goal with the fewest components, the better. You would still need to graph it to see if it is enough.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
