I can tell you that the ipod touches use DAC IC's that are fine pitched BGA packages that are glued to the board after soldering, you don't have a hope of doing anything with it

Read all the pages here on voltage regulators, explains it all as simply as it really can be put with lots of measurements included - http://www.tnt-audio.com/clinica/solidstate.html

Quote:   He also has to have trademarked the name to sue over that as well. Apart from the community frowning upon it and discouraging people against it, there is pretty much nothing you can do about it

Quote:   No, there is no regulator from 12V to 3.3V, Computers never use linear regulators for anything either (some soundcards and low power devices may, but they are exceptions). As has been said, 3.3V is used for some peripherals, but it's not used for high powered devices like the CPU...

Quote:     It is more efficient, in a nut shell. The drop doesn't matter at all for SMPS's, they have very good efficiencies where it is usually more efficient to run from higher voltage inputs. The wire connecting your PSU to the board don't need to be as heavy either, as there is less...

PCM2706 -> PCM1794 -> i/v converter -> 4channels of your favourite headphone amp   Read the datasheets of the parts I linked, start playing with a PCB layout editor, spend a few months playing with designs, look and research other peoples designs, and by the end you'll have something that'll...

  This pic is a bit old, that stack is a bit larger now with another small bench power supply, another matching DVM (2nd from the bottom), another DSO and a PC.   I don't have much suggestion on organisation, I use lots of boxes to put parts/projects in progress in so you can swap them out...

Quote: Originally Posted by ericj Your assumptions here are total nonsense. PLL clock synthesis has been the norm for 20+ years. They really can get 44.1khz spot on using a reference crystal that is not precisely divisible by 44.1khz. 'course, I think all clock upgraders (in...

Sorry, but that was the receiver side actually. The CS841x chips that are used as spdif receivers have differential inputs and this circuit converts the incoming spdif to a differential signal which is suppose to help. No, that transformer can't be used for analogue, it is designed to work...

Nearly all the time, none of the gear you buy actually does proper coax transmission and termination. You can't compare coax to toslink until you have the coax right, so for the best results you have to make the rx/tx circuits yourself For transmission you want the schematic posted by Jocko...

On crystals and jitter - DIYHiFi.org • View topic - What do you guys think about these?

Toslink is worse off than coax, so there is no point in upgrading your clock if you are going to shove it down some crappy plastic 14.18318Mhz isn't an integer ratio of any of the audio sample rates, so there has to be some stuff going on to make it to the same rate and that is going to...

Quote: Originally Posted by nightanole So i inherited a huge transformer from an amp. the problem is i have no idea on how to ohm it out to find primaries and secondaries. It just has 5 wires coming out of it. I assume that means 1 set of secondaries with a center tap? That is...

You need to wash it out with alcohol, get a good one if you can. Once it is washed off with that then it only needs minutes to dry from there, alcohol evaporates very quickly

If it wasn't that far out of my way and I had the spare time, I'm in the eastern suburbs and working long hours currently