also if any of you have experience with printing tubes i would like to hear as well.

would a consumer dlp printer like the mars 4 dlp suffice for printing tubing (like 1mm id 2mm od)? if not, are there any consumer printers that are up to this task? from what ive read dlp printers should have less problems with printing small holes

should i sand/coat my impressions before scanning them for 3d printing?

ah sorry for bothering you then, i just had trouble finding info regarding that

so i wont need to cure it under n2 to not have an inhibition layer?

is the siraya tech blu tough resin need to be printed under n2 to be bio compatible?

thats not a problem for me, im printing on a high accuracy printer that prints from the top down (it prints a layer then raises it and prints another layer below it) so im guessing it also has temperature regulation (btw which pro3dure resin am i looking for exactly? there are many on their...

do you guys know of a biocompatible resin for 3d printing with an inhibition layer?

has any of you experienced headaches after exposure to the acrylic?

how important is curing with glycerin? i ran out and its really expensive where i live

how long does it take to cure usually? im debating whether to let it cure overnight or do it in one day (im guessing it will take less than written on the box because of the small quantity)

very helpful. thanks guys

and washing it with water wouldnt do that just as well?

what is cleaning with alchohol needed for?

looks nice, but where did you get it from?