-
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.I wonder if there is a mod to acoustically attenuate 3kHz region by approx 1dB, it's not a fault per se, but it's probably the only... -
Many thanks and high praise to Head-Fi member asymcon, a frequent poster to this thread. When I recently posted about wanting a short...
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.:thinking: 2000 hours of 8hr daily use seems fair for any kind of pads. Also I replaced them not because of wear, but due to the fact I...
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Yes it should be possible.
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.roughly same sound here on all 3 pairs, same mods, first one sounded initially different after 2000 hours, but new pads fixed it
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Where are you based? I can make a straight cables, same way as I did for my 3 pairs of DT250, but I no longer have any spare connectors...
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.For me, Dt250-250 are amongst the easiest to drive HPs, so much so, that I use them even unamped straight from DAP/Audio interface
-
Posting back on this original thread of mine because I am about to get that old pair of mine back. This is a good test whether these...
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Of course, they blossom with time :gs1000smile: 3 years in, 2500 hours, and still my most favourite pair of HPs, and I have tried many...
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Anything compressible should be better than nothing. :)
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Bass till about 200Hz. There's a frequency response graph somewhere on the internet. You can also test through sine tones @50Hz
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Yes, this is what I do and it definitely helps. Next level would be to use plastic sealant on the tip of the screw.
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.OK, then I would say there won't be any issues. It's the edge of the connector and sealed screw hole that creates the seal. Even with...
-
asymcon replied to the thread The Beyerdynamic DT250 Thread.Channel imbalance? No. It'll either work fine, with both sides connected properly, or not work at all. Not sure how this 6pin connector...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
