-
-
dminches replied to the thread 2359glenn | studio.Glenn, it is great to see you back here and able to work on amps! I hope your health continues to hold steady. -
I will get that amp back to you. My problem now is I am to feeble to pick the amp up in the box. I will make no more amps with 3...
-
dminches replied to the thread 2359glenn | studio.I believe (and hope) Glenn is still around. I know Stavros speaks to him regularly but I haven't spoken to Stavros in several months...
-
dminches replied to the thread 2359glenn | studio.I wish I could be involved in the discussion but Glenn has had my amp for 4 years now and I don't think I am ever getting it back...
-
dminches replied to the thread 2359glenn | studio.The Horizon is a huge step up from the Pacific which is great as well. I traded by Pacific for an Horizon and am very pleased.
-
My preference is clear nail polish. A drop at each end into the crack between the glass and base then quickly wipe the extra off the...
-
Hard nail polish ("Hard as Nails") or crazy glue and a couple rubber bands. And a Cossor 53KU is good to go. :)
-
I use crazy glue in a little bottle with a brush. Just put in a little bit (a drop or two) and brush it into the space between the tube...
-
dminches replied to the thread 2359glenn | studio.What is the best way to fix a loose tube base? The tube works fine but the base moves. I assume I should use an epoxy or silicone? Can...
-
dminches replied to the thread 2359glenn | studio.I still follow the thread but I haven’t had my 300B for over 18 months now. :sweat:
-
dminches replied to the thread 2359glenn | studio.A lot of those DHTs look like RCA/Cunningham 112A, 01As, etc. Those are really nice tubes and are very cheap. I use them in my DAC.
-
I have struggled really hard about whether or not to post this given it's sensitive information, but Glenn has been very public about...
-
Wishing everybody a fantastic 2021. The bar's set pretty low now but we still have to try!
-
@dminches if you want to measure the DC voltage drop across the pins, use a DMM across the two large pins. If you want to measure...
-
dminches replied to the thread 2359glenn | studio.If I want to measure the amps and volts a 300B tube is pulling would I use a meter across the 2 heater (large) pins?
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
