I wear a Sieko Solar. SNE039. Got this when my Swiss Army Watch died.

Hi KSIX. I have only heard the E7K over phones. They are noted for separation (nearly perfect) so I hesitate to comment on speaker use. Still waiting to get the DAC side working.

Hi, I ordered and have the IRL510s on hand. If I can do the mods this will be the first one. As I stated earlier, I now have two V3s, and will mod both. Thanks!

Shabby, I know your pain! My first V3 (same electrical design) did the same thing but with a little different pulse. A low quick 3 burst pulse in about a quarter of a second that lasted about 1 second before repeating. Removed the top plex ond tryed turning rhe 2 tube bias pots. (Factory said to...

That works out well for you LeasingMan.because every one of your secondary interests(audio being the first of course) is affected by your love of watches. (I am satisfied by my Swiss Army Watch.)

Thank you sir!

Hi. I picked up a pair of "2200 uF Gold caps" as it looked like they were recommended and some 510 MOSFETs. Have not started iinstalling the caps (and I noticed you did not). May I ask which MOSFETs you ended up with? And which you recommend? (I know which end end of a soldering iron gets hot...

Thanks for the schematic! I seem to remember the voltage drop over a simple diode was maybe a volt os so. (Shottsky diodea were about half of that or so.) This should affecr the output of the MOSFET (IFR630 ?) and the voltaghe of the LM317. Been a long time! Sorry!

I was pretty sure that was your amp. It seems that you are happy with the performance and sound. And it looks good to boot! I assume that you used stand-off extensions to add the bottom level.  I still would like to know what the wires connect to on the bottom level. Thanks!

This is the V3 I found but it looks like it is yours! Came from DropBox.   https://dl.dropboxusercontent.com/u/39367418/Headphone_Stuff/bravo_v3-2_heatsink.jpg   Again, it is now my desktop wallpaper to study. Do you see why I asked about the wires going to the "basement" of the unit?

Thank you Euf0ira for the mod info. I had found a picture of a modded Bravo V3 (with the white LED) which prompted some of my questions. I have made it my desktop background for now! I  have two V3's because I purchased a new one to replace the first one. I will try and find the picture again...

For Euf0ira, those are some impressive looking mods! Can you tell me what the Caps are in value? I saw the one valed 2200 mF. I also see you have wired some elements to a common point (ground?) . Has this improved the hum? Thanks...

My understanding is that the red an blue LEDs are part of the circuit. They are diodes after all.

Yes, I did miss post #30. I have been reviwing all posts of the V3 mods, and I saw the mod with the white LEDs (not your's and not recommend). Still waiting for final use of IRL510 or IRL530. Ordered a non-contact Laser thermometer for $11 and change from Amazon just for proof of temps. Cant...

Had you replaced the heat sinks? And, just a thought, did you use "Arctic Silver" or equivanent between the regulators and the heat sinks?