paradoxper
Headphoneus Supremus
It's a common failure, no worry.You mean the tube is not dead? I can find the aligment but I thought the tubes are gone...
https://www.tubesandmore.com/products/keyway-replacement-piece-octal-tubes
It's a common failure, no worry.You mean the tube is not dead? I can find the aligment but I thought the tubes are gone...
Danny showed me the Sr1a and the Sr1b side-by-side and told me they are sonically identical. I thought the SR1b looked nicer. I have the Sr1a and have no need to change it.Is ther any sonic differences or improvements between Sr1a and Sr1b?
Thanks. I also have the srh1a before the rebrand to sr1a. Looks like I am going to get the CA1A instead.Danny showed me the Sr1a and the Sr1b side-by-side and told me they are sonically identical. I thought the SR1b looked nicer. I have the Sr1a and have no need to change it.
Stay updated on Moon Audio at their sponsor profile on Head-Fi.
|
https://www.head-fi.org/threads/raal-ribbon-headphones-srh1a.890603/page-346#post-16986985So, what are the differences between the SR-1a and the 1b?
Not very much, actually. The grille of the SR1 has been changed to match the grille styling of the CA1a and we replaced the internal copper wire (about 4 inches) with silver. The most significant change would be, for those needing a ribbon-to-amp interface, the original resistor interface has been replaced with our new transformer interface.
Sage, what was the rationale behind the change of the internal wire? Thanks.Not very much, actually. The grille of the SR1 has been changed to match the grille styling of the CA1a and we replaced the internal copper wire (about 4 inches) with silver. The most significant change would be, for those needing a ribbon-to-amp interface, the original resistor interface has been replaced with our new transformer interface.
I’m not Sage, but Aleksandr mentioned after months of making silver wires they had quite a few short silver scraps left over. Why not use them for internal wiring? It can’t hurt.Sage, what was the rationale behind the change of the internal wire? Thanks.
I use Monoprice monitor stands - they're not ideal but they're affordable and they're kind of attractive and unobtrusive.Can anybody recommend a desktop amp stand for the Jotunheim R? Something stackable would be ideal since I have 3 components.
I always thought this was a really clean looking setup for a desktop rig.Can anybody recommend a desktop amp stand for the Jotunheim R? Something stackable would be ideal since I have 3 components.
BTW - I noticed that Schitt is now selling the JR for $499.
Looks neat. Where is the stand fromI always thought this was a really clean looking setup for a desktop rig.