Just got a used little dot mk2 with matched Russian 6N6P+6J1P-EV
I'm a complete novice how are these rated ? Should I be looking to try something else
That is a great start
Just got a used little dot mk2 with matched Russian 6N6P+6J1P-EV
I'm a complete novice how are these rated ? Should I be looking to try something else
i think its good to have a load during start up and turn-off, and LD recommends the same. high impedance cans like the 600 & 650 are great for that. a 16 ohms load might not be the best though but the 300 works.
these things are not 100% accurate so during turn on and turn-off it helps to have a high imp load to absorb some of the leaked power. else its building up and amped.
Just got a used little dot mk2 with matched Russian 6N6P+6J1P-EV
Should I be looking to try something else
Wondering if someone could help.
Got a used MKII with 6N6P+6J1P-EV tubes.
I can barely tell a difference when comparing the sound vs my Solid State amp also not much difference with my ears to the stock tubes.
What would be best combo for a more tubey sound? Or are my ears just broken?
Wondering if someone could help.
Got a used MKII with 6N6P+6J1P-EV tubes.
I can barely tell a difference when comparing the sound vs my Solid State amp also not much difference with my ears to the stock tubes.
What would be best combo for a more tubey sound? Or are my ears just broken?
I disconnect from the power after I've finished listening.I guess it depends on your Fotografie skills how much the tubes are illuminated.
I just flip the power switch to Off, that disconnects the hot side of the AC line from the amplifier.
That's a new one for me, where the amplifier causes a headphone to warm up...