- Joined
- Oct 14, 2013
- Posts
- 28,357
- Likes
- 32,208
http://www.esstech.com/files/7914/4095/2159/SABRE9602C_PB_v0.6_141212.pdf
Not the "Q"...it's the "C" FYI and 49mW into 32ohm is not a general number it is an exact stated #.
The output impedance of the device is what? That's a pretty important #.
I stick with my comment. You will see this sexy phone and after a couple months most posted pics will be stacked. That ain't a bad thing. Plenty of thin supplemental power supplies available
RMS, Watt, Impedance are only general speaking. Linearity and continuity are the factors of pumped out dynamic.
http://www.webopedia.com/TERM/R/RMS.html
A speaker has peaks, and continuity. using the measurement of 49mW into a 32 ohms is only general number, what about continuity ? Simple put, a dynamic speaker...or speakers periods. They flex back and forth, the speed of their flexing, sensitivity, ohms load are all a part of their physical being. So yes, 49mW into 32 ohms is a general peak number.
Example, 2 drums of the same sizes and different housing material will sound differently. That is because their physically different even if they weight the same. The same as speakers. Planar magnetic is 30 ohms or so, but hell....they are hard to drive and need a good amp, and this is where pairing and syncing come into plays.
Another example would be a car that can peak to 175mph. But how long can it last, how fast can it get there ?
If the linearity and continuity supplied is not enough, the drivers will not perform as well.
But those are getting too scientific, and technical.
I repeat, adaptive pump and can drive maximum of 2Vrms into 600 ohms load....that mean 32 ohms is nothing. Hell even 300-400 ohm.
I will just stop here into sound science. All I have known so far is that this DAC OPAMP will be enough to drive most of hard to drive Hp....even Hd800 if needed be. Sound quality ? Subjectively. I need to hear it first.
Hey, if it hold you back, then don't buy. I am going to buy it ASAP