Hey
Just got a new battery for my DX100 today (awaiting it for over a month), 4 T5 torx screws(bought a cheap set of small torx, flat, phillips drivers for electronics) at each end and the back cover comes off with a little tug, battery is taped to the backplate, its 4,2V lipo's in series, 1 cable coming from the battery and a wire is also attached to the backplate. Don't pull the back cover too hard as these cables are fairly short. Battery is connected with a small connector on the bottom, as it's a stacked print, screen and so on, easy to locate and take out carefully with some pliers..
I wanted to load the russian firmware today, but i dont have any win 7 32bit, have a win 7 pro 64bit on hand but other pc's are win 10 32/64bit..
What can i do here? tried almost everything, i dont even get a pink button (1), all is grey and i'm reallysad here not to try it out..