[Wnt2bsleepin]

Hello All,
 
I was re-soldering the wires for my headphones and now one of the speakers does not work. I have tested the continuity for the wires, but the speaker seems to have failed. I was wondering if there was anyway to pry the actual speaker from the housing to see if I possibly messed up a solder joint somewhere from applying too much heat. 
 
 
Here is the can I am talking about. It looks like I messed up the contacts, but I am not too sure where they connect to the speaker. 
 
 
Thank you for any help.

 

[earthpeople]

There should be a gap between the two solder pads and it looks like they've been connected. I circled it in this picture; http://i.imgur.com/3L4apry.jpg
Try cleaning up that area and then soldering your wires to the spots marked with the blue squares.

 

[Wnt2bsleepin]

The two plates are isolated, I confirmed that with a multimeter. That crud in between is an insulator by the looks of it.

 

[BauerFIve]

Not sure about prying the speaker out of the housing. Could clean up the solder off the contacts and attempt to pry the board out [however this maybe irreversible.] 
 
I did find a few links [though you probably have already seen them about repairing/DiYing the wires]
 
http://www.head-fi.org/t/568601/doing-my-first-recable-grado-sr-60-some-quick-guidance
 
http://www.youtube.com/watch?v=0JHGJqfM0wE

 

[Wnt2bsleepin]

I might just have to send them into Grado. Hopefully they won't be too expensive.