Loquah
Headphoneus Supremus
I'am wondering if i can use a 6SN7 for input and output tubes for the CRACK?
There may be people that can answer that question here, but definitely there will be on the Bottlehead Forum
I'am wondering if i can use a 6SN7 for input and output tubes for the CRACK?
I think their site is down.Thanks!
I'am wondering if i can use a 6SN7 for input and output tubes for the CRACK?
I always ask and wondering, how does Crack sound with Modi or Odac. I buy both to answer my own question. I think it's my end game already. But Modi mainly connected for my Crack due to it's better appearance.
I don't think the pot will have any effect on that reading. What your trying to measure is the 270k bleeder resistor to discharge the power supply but some meters have trouble with this as the meter itself starts to charge the capacitors while testing.
Check the center pin of the two RCA inputs read ~100k ohms, and the grounds read as close to 0 ohms as your meter can read and you should be good to go.
Also if you are using an attenuator like the Valab make sure the grounds on each side of the attenuator are joined together.
Out of interest, how would you compare the sound of the Modi vs the Odac?