Why does my STEPS ground measure -10v?
Oct 25, 2007 at 1:26 AM Post #17 of 19
Quote:

Originally Posted by holland /img/forum/go_quote.gif
So, your whole thread has lost me.

Are you getting the DC voltage you are setting for? Ripple voltage aside. If so, then your STEPS is properly converting to DC at the voltage you are setting. If not, it could be your regulator.

If you are able to measure ripple @ TP4 and TP5 then there's a chance that your regulator (not rectifier) is not working, which should probably show on your DC side.

So, again, are you getting the proper voltage at TP4 and TP5 DC?


The regulator is changing the voltage like expected.
 
Oct 25, 2007 at 4:23 AM Post #19 of 19
Quote:

Originally Posted by holland /img/forum/go_quote.gif
Do you measure the same amount of ripple at TP3?



It is slightly higher at around 45-50v.


EDIT: I have new regulators ordered, 60V 15amp.
 
You must log in or register to reply here.

Users who are viewing this thread

Total: 2 (members: 0, guests: 2)
Back
Top