segacanyon
New Head-Fier
Hello,
Years ago, sound on my T1 started cutting out on the right side. I acquired a replacement cable straight from Beyerdynamic, but only recently have I attempted to actually replace the cable (having basically no soldering experience, I was a bit hesitant).
Following a guide in an old thread on here, I managed to replace the cable and everything seemingly worked. Then I discovered the left and right channels were reversed. I swapped the cables going into each driver, but the left and right were still reversed. I swapped them back, this time making sure I didn't accidentally connect the cables into the same driver, but still got the same result. It seems like no matter what I do left and right are always reversed.
Would hooking the cables up to the wrong polarities cause this? Or maybe it's something else. Any ideas? Thanks in advance!
Years ago, sound on my T1 started cutting out on the right side. I acquired a replacement cable straight from Beyerdynamic, but only recently have I attempted to actually replace the cable (having basically no soldering experience, I was a bit hesitant).
Following a guide in an old thread on here, I managed to replace the cable and everything seemingly worked. Then I discovered the left and right channels were reversed. I swapped the cables going into each driver, but the left and right were still reversed. I swapped them back, this time making sure I didn't accidentally connect the cables into the same driver, but still got the same result. It seems like no matter what I do left and right are always reversed.
Would hooking the cables up to the wrong polarities cause this? Or maybe it's something else. Any ideas? Thanks in advance!
