Search results for query: *
- Users: Gman
- Content: Threads
- Order by date
-
Need replacement for UA739PC opamp. Can anyone help?
It can be replaced with a NET725 but I would rather upgrade the opamp not just replace it. The opamp goes in a driver board for a Harman Kardon citation 16. Any help is appreciated. Thanks. G- Gman
- Thread
- Replies: 5
- Forum: DIY (Do-It-Yourself) Discussions
-
Pete Millet's Hybrid amp.
Anyone seen this? http://www.pmillett.addr.com/hybrid_head.htm G- Gman
- Thread
- Replies: 6
- Forum: DIY (Do-It-Yourself) Discussions
-
All Discrete Szekeras with gain stage.
Hi guys, I've been working on this circuit for a couple of days now and I think it's ready for comments (good or bad). This all started when I ran across this schematic: http://members.tripod.com/~gabevee/sstubepre.html I thought that the circuit would make a good headphone amp with a few...- Gman
- Thread
- Replies: 2
- Forum: DIY (Do-It-Yourself) Discussions
-
Is Michael Percy on vacation again?
I've sent an order to Michael by email 4 times in the last week and have gotten no reply. Does anyone know if he's out of town or is he running that far behind? Thanks.- Gman
- Thread
- Replies: 9
- Forum: DIY (Do-It-Yourself) Discussions
-
Elantec EL2009C vs BUF634?
Which would you use in a circuit to drive low impedance headphones?- Gman
- Thread
- Replies: 9
- Forum: DIY (Do-It-Yourself) Discussions
-
Calling all PCB layerouters :).
Hi guys, I have attempted over the last couple of days to lay out a solid state(gasp!)headphone amp using ExpressPCB. It is a OPA627 with a BUF634 inside the loop(Jung multiloop style). I just wanted to get some learned opinions of the layout before I start to work on the regulated supply. I...- Gman
- Thread
- Replies: 3
- Forum: DIY (Do-It-Yourself) Discussions
-
New Tube Design.
Hello All, I've finally finished (theoretically) the tube headphone amp design that I have been working on too long. This is a pretty involved design as far as the filament supplies and the PSU go. The amp is pretty straight forward though. This is not a cheap design even if you don't use...- Gman
- Thread
- Replies: 7
- Forum: DIY (Do-It-Yourself) Discussions
-
How to couple Jfet gain stage to Szekeres's MOSFET amp
I would like to use the JFET Preamp circuit found at the link below as a gain stage (actually stages) and use the Szekeres Mosfet driver as the output stage. My question is can I delete the input cap on the Szekeres driver since the preamp has a output cap? Also the preamp circuit has the volume...- Gman
- Thread
- Replies: 1
- Forum: DIY (Do-It-Yourself) Discussions