What's your recipe?

piotrus-g do you agree with this? What do you think?

So, based on your advice, would this be the go-to design? Cap values based on what I have (0.22 uF) and what I can find online (4.7 uF). Also, advice on tube length and damper choice if you can. I thought of putting the SWFK as close to the nozzle as possible and the CI with a 1mm ID tube and...

So as per this diagram, it would be better to invert the ED so that the positive line with the caps enter the negative terminal in order to maintain the phase.

Is the SWFK-31736 good for the high end, or should I have gone for a TWFK? My plan was to build a full BA IEM as a personal project, and I got myself the CI-22955 and ED-29689 as well as the SWFK. Also, I found this diagram deep within this thread (I redrew it, can't find the page for the...

Explain further, inverting the phase?

When you're trying to crossover drivers, do you have to take into account the driver's own impedance? Does every driver have to have similar impedances for them to work well together? When calculating for R for high/low pass filters, what else should be taken into account besides the resistor to...

So you're saying capacitor and resistor low pass filter can work with dynamic drivers, just not inductor and resistor ones.

Another question: Does the usual RC low pass filter work as well with a DD as it would with a BA? What should I take into consideration if I want to use a DD for bass and lower mids?

Questions regarding designing crossover circuit for multi BA iem: 1. Regarding RC low pass filter, is the direction of the capacitor flow from BA out to BA in? All RC filter diagrams I've seen had no indication on which side of the capacitor is the (+) or (-), so I'd like a confirmation. 2. Is...