-
-
PpeterSwe replied to the thread Elekit 300B Amp kit.Hi, I promise I wont put wires instead of resistors! Thanks for the heads up, my question probably reflects more on my language skills...
-
P@peterSwe , Elekit was my first project and I didn’t attempt these mods when I first built it. Building it gave me the opportunity to...
-
PpeterSwe replied to the thread Elekit 300B Amp kit.Thanks! I understand that you and you friend have extensive knowledge of the 8900 (and electronics in general). I need to find the tread...
-
PpeterSwe replied to the thread Elekit 300B Amp kit.I’m not sure what’s deepest? The rabbit hole or the hole in my wallet…? If upgrading immediately when building, what parts and in what...
-
PpeterSwe replied to the thread Elekit 300B Amp kit.My speakers are very sensitive. 104 db. Maybe the 2a3 tubes are more ”bang for the buck” vs 300-tubes? Would you recommend any specific...
-
PpeterSwe replied to the thread Elekit 300B Amp kit.I just did it! 8900vk is ordered and it will eventually have a dedicated pre amp. I’m really looking forward to build and listen to it...
-
PpeterSwe replied to the thread Elekit 300B Amp kit.Hi all, Maybe a stupid question: Could I run the 8900 directly from my RIAA putting out 240mV? Or could I run it from headphone out on...
-
PI will give you the resistors for the left channel: 1. R102 - it is the only resistor in the signal path in the amplification stage...
-
PpeterSwe reacted to scottme's post in the thread Elekit 8600 as Headphone amp: Making the good better with
Like.
Hi all, TLDR: Exploring modding the Elekit TU8600 to make it a better headphone amp. An Elekit 8600S (Lundahl) is on the way to me. My... -
PpeterSwe replied to the thread New Member Introductions thread.Hi all, Building, or restoring/modifying, a Technics SP10 mk2 for my home office made me explore the world of headphones.(my wife also...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
